The Enabled setting enables the BIOS to try all three types, i.e. "First Boot Device", "Second Boot Device" or "Third Boot Device". Gate A20 Optionĭefines how the memory above 1MB is accessed. This should be set to Fast, in order to activate access through the chipset. With the Normal setting it is accessed via the keyboard controller. This option may speed up older computers. The first 64 K Block above 1 MB can be accessed in standard mode via address line A20. DOS will anchor itself there, if DOS=High is inserted in Config.sys. This parameter is used to specify whether the options Keyboard Typematic Speed, Delay Before Keys Repeat, Typematic Rate or Typematic Delay are available. If Disabled, the values are set to 6 characters per second, with a keyboard delay of 250 ms. The settings can also be specified via the operating system. Specifies the repetition rate of the keyboard when a key is pressed. This value determines when the key function is activated after a key is pressed. The options are 250, 500, 750 or 1000 milliseconds. This parameter specifies the option for which a password applies. If the SYSTEM option is selected, a password has to be entered during PC start-up. If the SETUP option is selected, a password is only required for accessing the BIOS. This parameter switches the APIC Controller (Advanced Programmable Interrupt Controller) on or off. According to the PC2001 regulations, the system may run in APIC mode. Settings: Enabled or Disabled MPS Version Control For OS APIC mode offers extended IRQ resources (depending on the board). This option specifies what MPS version (Multi-Processor Specification) is used by this board. Setting options: 1.1 or 1.4 For older operating systems 1.1 should be used, otherwise leave as 1.4. OS Select For DRAM > 64 MBįor OS/2 systems with more than 64 MB RAM, option OS/2 should be used. This option should be set to Yes, if no floppy drive is installed. This option enables IRQ6, and the Windows logo is skipped. This option can be used to specify that the start logo should fill the whole screen during booting, thereby hiding the start data. Setting options: Enabled, Disabled.This manual discusses Phoenix Technologies's Setup program built into the ROM BIOS. The Setup program allows users to modify the basic system configuration. This special information is then stored in battery-backed RAM so that it retains the Setup information when the power is turned off. The Phoenix Technologies AwardBIOS installed in your computer system's ROM (Read Only Memory) is a custom version of an industry standard BIOS. This means that it supports Intel/Cyrix/AMD processors in a standard IBM-AT compatible input/output system. If you've recently added new hardware or resetting the default values did not help resolve your boot issues, you may also want to reset the configuration data.The BIOS provides critical low-level support for standard devices such as disk drives and serial and parallel ports. Once the default values are set, make sure to Save and Exit.Press Y for yes or arrow to the yes option. When found and selected, you are asked if you're sure you want to load the defaults.Other setups may list an option that you can arrow over to using the arrow keys and pressing Enter. For example, the F5, F6, F9, F11, or F12 key, as shown in the picture, may be set up as a shortcut to load the default settings. With many CMOS setup screens, there is a function key to do this. In CMOS setup, look for an option to reset the CMOS values to the default setting or an option to load the fail-safe defaults.How to enter and exit the BIOS or CMOS setup.To reset your computer's CMOS or BIOS (basic input/output system) settings back to the default settings, follow the steps below. If you're seeing an error about a "media test failure," there may be a loose cable inside the computer or the hard drive might be bad.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |